You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
You are viewing the article in preview mode. It is not live at the moment.
Home > Counter Surveillance > Cell Phone and GPS Detector Manual (007-PHONE-GPS-DETECT)
Cell Phone and GPS Detector Manual (007-PHONE-GPS-DETECT)
print icon

FAQs

Bug detectors, though slightly more complex than camera detectors are fairly simple to use. Since bugs transmit RF (radio frequency) signals, bug detectors hone in on those signals and indicate that there is a bug present, by lighting up, making a sound, or both. Please keep in mind that since bug detectors are designed specifically to pick up any RF signal in a given area, you may receive "false" positives if another RF-transmitting device (cell phone, radio, microwave, etc.) is nearby and active while you're doing a bug sweep.
Before you begin, you should turn off, unplug, and/or disconnect any communication devices that you are already aware of in the space you’re scanning. Once this is done, turn on your RF detecting device.
No matter which type of RF detector you're using, it’s important to take your time with the scanning process and be patient. Some bugging devices may not register a signal immediately, so you may need to continue the scan while waiting for a transmission. For example, a GPS tracker placed in a vehicle could be programmed to transmit data back to the user who placed it every 10 seconds, or it could be programmed to only transmit every 10 minutes. It depends on how the user programmed the device. Because of this, it may be necessary to turn on the detector and wait until the bugging device you’re looking for makes a transmission. Until that time, a signal will be undetectable.
 
 
Please see below for full instructions in the attached copy of the Manual for this device.
Feedback
0 out of 0 found this helpful

Attachments

DD3200_manual.jpg
scroll to top icon