Before drilling please check that no cable or wiring is on the other side of the wall. Please clamp all wires securely to reduce the possibility of them being damaged while the vehicle is in use. Keep all cables away from hot/moving parts and electrical noisy components.

We recommend doing a benchmark test before installation to ensure that all components are working properly.

Step 1: Choose the monitor and camera locations.

Step 2: Install all cables in the vehicle, when necessary a 0.8 (20mm) hole should be drilled for passing camera cable through vehicles walls. Install split grommets where applicable.

Step 3: Once all cables and wiring have been properly routed, perform a system function test by temporarily connecting the system.

Attached below is a copy of the Manual for this device. For technical support, please contact the manufacturer's dedicated support team at (800) 764-1028 or send an email to [email protected].